By Gene and Katie Hamilton
Step 1 : Turn off the water
Turn off the controls to the hot and cold water valves usually located behind or above the washing machine.
Step 2 : Disconnect and unplug
Unplug the machine's power cord. Disconnect the hot and cold water supply hoses at the water valves. If you have to move the washing machine to reach the hoses, carefully push the unit away from the wall so you can access the back where the hoses are located. Use a wrench if the hose fittings are rusty.
Step 3 : Connect the solenoid valves
Connect the inlet side of the hot and cold solenoid valves to the hot and cold water valves where the washing machine water supply hoses were connected. Then connect the washing machine water supply hoses to the outlet side of the hot and cold water solenoid valves.
Step 4 : Connect the cords
Connect the two electrical cords from the control box to the hot and cold solenoid valves.
Plug the control box into the 115-volt wall outlet where the washing machine was plugged in. Then plug the washing machine power cord into the control box.
Step 5 : Open the valves to turn on the water
Open the hot and cold water valves and check for leaks.
Illustrations courtesy of CasMont Industries, Inc.
Get Pro Help