Step 4 : Remove the duct knockouts
Use a screwdriver to unfasten the duct knockout panels from the top or back of the hood.
Step 5 : Prepare the damper/duct connector
Remove tape from the damper flap and attach the connector over the knockout opening with the screws you removed earlier.
Step 6 : Connect the wiring
Protect the surface of the cooktop with heavy cardboard and set the range hood on top of it. Then connect the house wiring to the hood. Connect the house black wire to the hood black wire and the house white wire to the hood white wire. Then connect the house ground wire under the ground screw and tighten the cable clamp onto the house wiring.
Step 7 : Hang the hood
Use the mounting screws to install the hood. Then slide the hood towards the wall until the mounting screws are engaged. Tighten the screws securely with a long handle screwdriver. Then replace the bottom cover.
Step 8 : Connect the ductwork to the hood
Fasten the ductwork to the hood using duct tape to secure joints and make them airtight.
Step 9 : Finish the assembly
Install the light bulbs and replace the filters and turn on the power at the service panel and check for proper operation.
Illustrations courtesy of Broan-NuTone
Page 2 of 2
Back to Page 1