By Gene and Katie Hamilton
Step 1 : Lay out the vanity top
Lay out the vanity top polished side faced down on top of the vanity cabinet.
Step 2 : Unpack the sink and test fit
Unpack the sink and place it upside down over the sink hole in the vanity top. Be sure the back edge of the sink sits between the faucet holes and the inner edge of the sink hole in the top. Line up so the sink is even and completely covers the sink holes. Feel underneath to be sure there is an even edge around the sink. It's OK if the front and back edge are not perfectly even, but the left and right sides should be as close to even as possible.
Step 3 : Outline the sink with a guideline
Use a marking pen and draw a line all around the sink.
Then make a small line through this line on the front and back of the sink and vanity top. These line will be your guide when you glue the top down with epoxy.
Page 1 of 2
Go To Page 2
Get Pro Help